Hello,

I have bought a heater, since I have switched from HPS to LED lights. Now there is no heat from lights and it gets cold in my box.

Is it possible to set different conditions depending on lights? Lets say I want some temperature during lights on and less temperature while lights off.

Thanks

​

Hi,

first of all I would like to thank u/The3rdWorld for Pigrow as it is an amazing piece of software. I really like it and it works as it should be.

The issue I am experiencing is hardware related. I have been using DHT22 before and it worked only sometimes. Got tired using it and bought BME280. Got it running too, but only to the point when relay module get switched. Then it is all over (No I2C device at address: 0x77). If I turn raspberry off and on again, pigrow reads the data well. Until it switches the relay module.

I am using quite obsolete hardware - Pi , model B, rev. 2. Could newer raspberry solve the problem? Or should I buy new relay module? Or can be the new bme280 faulty? Dont know.

Any ideas?

Thanks a lot.

Lukas